Q ACOUSTICS CEILING SPEAKERS

Q ACOUSTICS CEILING SPEAKERS
Q ACOUSTICS CEILING SPEAKERS Q ACOUSTICS CEILING SPEAKERS
Product Code: QI-65CB
Availability: In Stock
Price: £65.00
Qty:     - OR -   Add to Wish List
Add to Compare

The Q Acoustics QI65CB speaker has been designed to offer exceptional value in terms of performance and cost, its efficiency is particularly high, in fact it requires less than half the amplifier power of the standard Qi65C to produce the same volume of sound. It is also incredibly shallow making it Q Install's slimmest speaker with a maximum rear depth of just 73mm.

The full range driver has been carefully designed to give good bass extension a detailed mid-range for voice reproduction amd an extended high frequency range without the need for a coventional crossover and tweeter arrangement.

 

FEATURES

 

  • Bezel and grille design that clips magnetically into place, with the grille geometry being carefully optimized to ensure the perfect balance between sound and discreet appearance
  • The HF is adjustable by + or - 3dB from a switch on the crossover
  • Circular and square grille options are available to ensure the perfect match for each customer's decor.
  • Only 6.5” in diameter, they are hardly visible in your home and take up virtually no space
  • Less than 84 mm deep.
  • 'UL94' flame retardant materials
  • Moisture proof
  • Q Install speakers come carefully packaged with installation template and fitting instructions

SPEAKER SPECIFICATIONS

 

Tweeter: Swivel
Tweeter diameter: 0.75" (19mm)
Woofer diameter: 6.5"
Power handling (program): 15-60W
Impedance (nominal) ohms: 8ohm
Sensitivity dB spl (2.83V, 1m): 89
Response(Low freq.) -3dB Hz: 75
Maximum rear depth: 79mm
Size(Round grilles): 232mm dia
Warranty: 5 Years
  • HOW TO GUIDE

    STEP 1

    Select a suitable mounting location for the speaker taking note of the Warning Notices above. Using the installation template supplied mark the speaker position and cut the mounting hole. 

    STEP 2

    Make sure all equipment is switched off.  The speaker cable should be stripped back ~10mm so that there are bare wire ends. Remove the packaging and protective dust cover from speaker and attach the speaker leads using the pushdown spring clip terminals at the rear of the speaker. The positive conductor should be connected to the red terminal and the negative conductor to the black terminal. For single stereo versions there are two sets of terminals for connection of left and right channels.  

    Note: Tweeter output level adjustment (‘P’ & ‘CW’ versions)

    It is recommended to leave the switch in the ‘0’ position for the initial sound check.

    STEP 3

    Check that each of the 4 swing out clamps are rotated inwards. Push the speaker through the mounting hole and position flush with the ceiling. Whilst holding the speaker in place tighten each of the mounting screws using a No. 2 Pozidriv® screw driver in the order shown in the diagram (left). When an increase in resistance is felt the clamp is in position.

    STEP 4

    Once the speakers are installed they should be tested before the grilles are fitted. The tweeter’s outer frame (not dome) should be pushed gently to achieve the desired tweeter position.

    STEP 5

    The 6.5” Professional in-ceiling single stereo speaker features a magnetic grille, locate the grille over the speaker bezel where it will be pulled into place. Note that square grilles may be positioned at any angle required. 

    Some models feature a white backing cloth behind the grille to help minimize visual contrast with the ceiling. For the very best sound performance it is recommended that this cloth is removed before use. To remove simply peel away the backing cloth from the grille.

     

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below:



Web Design by iTE Systems